YUKEN電磁溢流閥,全新YUKEN電磁溢流閥

是供給壓力14MPa 油溫40℃（粘度40mm2/s）的代表值
To make pressure adjustmentloosen the lock nut and
the screwclockwise.Be sure to re-tighten
zui小調整壓力等于值從zui小調整壓力得到
特色加的油箱管路背壓下頁這個背壓應包括中的T型線路壓降特性
turn the pressure adjustment
鎖緊螺母擰緊使調整到壓力后在小流量的情況下

YUKEN電磁溢流閥,全新YUKEN電磁溢流閥
If the pressure is set below 1.9
The minimum adjustment pressure equals the value
MPa (280 PSI), the m aximum flow is
limited. See the m inimum adjustment pressure vs. m aximum flow
打開壓力調節(jié)螺釘順時針或逆時針于
增加的壓力轉動螺絲順時針定要牢牢重新
screw clockwise or anticlockwise.
For an increase of pressureturn the screw
clockwise. Be sure to re-tighten the lock nut firmly
是使用本公司制放大器時的值反應時間
閥堆疊模塊化的基板側為了使壓力調整松開鎖緊螺母
設定壓力可變得不穩(wěn)定為了避免這種情況指的是下頁的zui小流量特性曲線并使用的范圍內的閥如圖所